The LokSound by ESU LokPilot Standard DCC Decoder is a general-use, non-sound decoder suitable for use in a variety of locomotives. Available with 21MTC, NEM652 8-pin and PluX12 interfaces. It's for use primarily in HO, TT and N Scale locomotives. Based on a 32 bit CPU, the LokPilot Standard features excellent load control and very good low speed characteristics, all in an affordable decoder.
The LokPilot Standard offers 14 - 128 speed steps and two and four-digit addressing. On systems with RailComPlus the decoder automatically registers at a compatible command station (ECoS). It supports all DCC programming modes and can be operated and programmed with all DCC compatible digital command stations. If using RailCom you can also read out CV values on the main with a suitable command station. Programming is easy with the ESU LokProgrammer where you can see all parameters in plain text on your PC monitor.
The LokPilot Standard decoder outputs 0.9A continuous current and easily handles all commonly available DC motors as well as coreless motors. Load control with 20 kHz PWM frequency assures quiet running and lets your locomotives crawl slowly over your layout. Load control can be optimized to most motors by means of three CVs. Due to the simulated inertia the locomotive will not jerk, even in 14 speed step mode. The LokPilot Standard is a dual-mode decoder and can be used on analogue DC layouts.
The LokPilot Standard decoder has four function outputs. The version with the 21MTC plug has two additional outputs without end stage for controlling lighting and other functions in conjunction with a suitable adapter board (397-51968). All important lighting functions (blinking lights, Mars light, flashing light) are available and can be set just like the brightness of each output. The integral shunting mode assists you in switching, and can be enhanced with the option to turn off acceleration and deceleration with a function button. Function mapping using the NMRA standard is available for F0 to F20. The decoder firmware can be updated when necessary using the LokProgrammer.
LokPilot Standard DCC Decoder is part of the line of ESU LokSound decoders.
The LokPilot Standard offers 14 - 128 speed steps and two and four-digit addressing. On systems with RailComPlus the decoder automatically registers at a compatible command station (ECoS). It supports all DCC programming modes and can be operated and programmed with all DCC compatible digital command stations. If using RailCom you can also read out CV values on the main with a suitable command station. Programming is easy with the ESU LokProgrammer where you can see all parameters in plain text on your PC monitor.
The LokPilot Standard decoder outputs 0.9A continuous current and easily handles all commonly available DC motors as well as coreless motors. Load control with 20 kHz PWM frequency assures quiet running and lets your locomotives crawl slowly over your layout. Load control can be optimized to most motors by means of three CVs. Due to the simulated inertia the locomotive will not jerk, even in 14 speed step mode. The LokPilot Standard is a dual-mode decoder and can be used on analogue DC layouts.
The LokPilot Standard decoder has four function outputs. The version with the 21MTC plug has two additional outputs without end stage for controlling lighting and other functions in conjunction with a suitable adapter board (397-51968). All important lighting functions (blinking lights, Mars light, flashing light) are available and can be set just like the brightness of each output. The integral shunting mode assists you in switching, and can be enhanced with the option to turn off acceleration and deceleration with a function button. Function mapping using the NMRA standard is available for F0 to F20. The decoder firmware can be updated when necessary using the LokProgrammer.
LokPilot Standard DCC Decoder is part of the line of ESU LokSound decoders.